Orem, Utah+1-253-294-9359info@waterdamagerestorationoremut.usServing Orem and Nearby Cities
Home / Services / Structural Drying
Orem, UT

Structural Drying in Orem, UT

Why a floor that feels dry can still be wet inside, how drying is actually done, and how you can tell it is finished.

Surface-dry isn't dry

Water that soaks into drywall, framing, subfloor and concrete doesn't leave just because the surface feels dry. Closed wall cavities and the space under flooring hold moisture for days if nothing moves it out. Left there, it causes swelling, musty odors, paint failure and eventually mold. Structural drying is the process of pulling that moisture out on purpose and proving it's gone.

The equipment, in plain terms

  • Air movers blow air across wet surfaces so water evaporates.
  • Dehumidifiers pull that moisture out of the air so it doesn't settle back into the walls. Low-grain refrigerant (LGR) units are the common type.
  • Moisture meters measure how much moisture is in drywall, wood and concrete.
  • Thermal cameras show cool, wet areas behind walls so they can be checked.
  • Wall-cavity and subfloor drying setups push dry air into spaces that would otherwise mean opening everything up.

How drying is monitored

A drying job isn't set-and-forget. Readings are recorded on day one, checked every day, and equipment is moved or pulled as areas reach their target. Targets come from comparing wet materials against a dry reference reading from the same material elsewhere in the house.

The standard that guides this work is ANSI/IICRC S500, which also groups water losses into classes by how much moisture the materials absorbed. You don't need to memorize it, but it's fair to ask a company whether it follows it, and whether you can see the daily readings.

How long does it take?

Most jobs run a few days. Thin materials like drywall dry quickly. Hardwood, plaster and concrete slabs take noticeably longer. Utah's dry air helps in summer, but closed-up winter houses and finished basements dry slower, which is why measurements matter more than a calendar.

Living with the equipment

It's loud and it warms the room. Expect fans and dehumidifiers running around the clock and a bump in your electric bill. Please don't switch units off overnight: the dehumidifier cycle is what actually removes the moisture. If the noise is a problem, say so and ask about placement.

When drying isn't the answer

Some materials aren't worth drying. Carpet pad, wet insulation and drywall that was soaked with dirty water are commonly removed instead. Contaminated water changes the whole plan; see sewage cleanup and flood damage.

Common questions about structural drying

How do you know my home is dry?

By measurement. Readings in the affected materials are compared with a dry reference reading, and drying stops when they match closely enough. You can ask to see the log.

Why so many fans?

Moisture leaves surfaces by evaporation, and evaporation needs moving air across every wet surface. A small room can need several air movers because each one only covers so much area.

Can I use my own fans and a dehumidifier?

For a damp-towel-level problem, sure. For wet walls or floors, household equipment rarely moves enough air or removes enough moisture to reach drying goals.

Will drying prevent mold?

It lowers the risk a lot, because mold needs sustained moisture. The EPA's general advice is to dry wet materials within 24 to 48 hours, so speed matters.

Can wet hardwood floors be saved?

Sometimes. Hardwood caught early can often be dried with specialty equipment, though it may cup or buckle before it settles. Severe cupping, or water that came from below, can mean replacement.

Related services

Call NowFree Estimate